Close
All Categories
    Filters
    Preferences
    Search

    Batteries

    Batteries

    View as Grid List
    Sort by
    Display per page

    12V 3000 mAh NiMH Battery Pack - PP45

    70018
    #70018
    $44.99

    The Studica 12V 3,000 mAh NiMH (nickel metal hydride) Battery Pack, PP45 comes with a w/20 amp fuse. It is a 10-cell, 12-volt rechargeable battery pac k that brings long-lasting power to motors and electronics that are used in the WorldSkills Mobile Robotics Collection. The Studica NiMH Battery Pack Charger, PP45, is required to charge the battery.

    Specifications,

    • Dimmensions: 5 x 2.1 x 2.1 inches (115 mm x 45 mm x 50 mm)
    • Weight: 1.32lbs (579 g)
    • Built-in 20-amp replaceable fuse for safety
    • 10-cell pack provides 3,000-mAh capacity for longer life
    • PP45 connector for easy and safe connection to controller
    • Step File

     

    NiMH Battery Pack Charger - PP45

    70019
    #70019
    $29.99

    The Studica NiMH Battery Pack Charger, PP45, is used to recharge the 12V 3,000 mAh NiMH Battery Pack, PP45.  It is a smart charger that auto detects battery pack voltage, sets up proper charging voltage and cuts off power automatically by negative delta V IC when the battery pack is fully charged.

    Specification:

    • PP45 connector for quick and safe connection to battery pack.
    • Input: AC 100-240V
    • Output Voltage: 7.2V-12V
    • Charging Current: 0.9A/1.8A
    • Applicable Battery Types: NiMH/NiCd
    • Do not overcharge
      • Disconnect the battery from the charger once it indicates a full charge.
      • Typical charge time does not exceed 2 hours.
      • Do not charge a battery that hasn't been discharged significantly. Running the robot under minimal load for a few minutes will not significantly discharge the battery.
    • Minimum no-load voltage: 9.0V
      • Discharging the battery past 9.0V can reduce the lifespan of the battery and can permanently damage the cells.
      • Periodic dips below 9.0V when under load is expected and OK. Don't forget to unplug your battery after you are finished running the robot and don't run your robot until it completely stops responding!
    • Operating Temp: 0 ~ 40°C
      • Let the battery cool before and after charging.
      • The battery may feel warm after heavy loading or after charging. This is normal

    6V DC Battery Holder for Smart Robotics Servo Programmer

    75004
    #75004
    $4.99

    Use it to power the Studica Smart Robot Servo Programmer or any other device requiring 6V output and a TJC8 connector. 

    Specifications:

    • 6V Output
    • On/Off Power switch
    • TJC8 connector
    • Uses 4 x 1.5V AA Batteries (not included)

    Batteries