Clamping 6mm Hex-Shaft Hub

The Studica Robotics Light Weight 6mm Hex-Shaft Hub (2 pack) are used with 6mm Hex shafts. They have a 5mm set screw for tight clamping and seven M3 tapped mounting holes.

The Studica Robotics 6mm Hex-Shaft Hub (4 pack) is used to connect any Studica wheel and/or motor with a 6mm shaft.

The Studica Robotics 1-1 Motor Hex-Shaft Kit can be used with the Studica Maverick or any FTC legal motor such as the Neverest Classic (6600 RPM) or the REV HD Hex motor (6000 RPM). The kit includes a faceplate which supports the Studica Robotics building platform. The shaft is press-fit onto the motor's shaft.

The Studica Robotics enhanced wheel Hex-shaft hub kit is ideal for use with the Omni and Mecanum wheels for a strong axle hold.

The Studica Robotics 6mm Hex-Shaft Low Profile Clamping Hub is an ideal fit for our motors.

The Studica Robotics 6mm Hex-shaft collar clamp (2-piece) has a 6mm Hex-hole and dimensions of 20mm x 8mm.

The Studica Robotics 6mm Hex-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.