The 120 Degree Bracket is perfect for connecting two channel pieces at 120 degrees from each other. Each side is 48mm wide to fit perfectly on the channel. Use three brackets with 3 channel pieces to make 3 wheeled robots. As with the other Studica Robotics building components, it has the common hole pattern which makes it easy to connect to other structure with very little or no additional machining required. You can easily connect to other channel, extrusions, bushings, bearing, mounting brackets and more so you can quickly assemble and disassemble robots and automated systems.

Specifications:

• Material - Anodized 6061-T6 Aluminum
• Thickness - 3mm
• Step File

The 6mm diameter D Shaft is made of stainless steel and is used throughout our building system as drive components. The D Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.

Specifcation:

• Stainless Steel
• 96mm length
• 6mm OD
• 5.5mm to flat
• Step File

The 6mm diameter D Shaft is made of stainless steel and is used throughout our building system as drive components. The D Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.

Specifcation:

• Stainless Steel
• 70mm length
• 6mm OD
• 5.5mm to flat
• Step File

This 5.5mm Combination Wrench ships with most of our kits works with all the M3 nuts available on our store.

M3 Stainless Steel Nyloc Nut (100 pack)

• Step File

This Hex Ball End Screwdriver can be used with most of the M3 screws.

The Studica Robotics 6mm Hex Shaft Servo Hub 25T is made of anodized 6061-T6 Aluminum and is used to connect a servo motor to a Hex Shaft axle.

The Studica Robotics 6mm Hex-Shaft Rack and Pinion Set includes 1 Rack, 1 Pinion, and 2 Glides. The rack hole pattern matches that of the channel, flat beams, square beams and flat brackets so it's easy to mount on the Studica Robotics structure.