I2C to I2C 3pin female to female cable - 22WAG

The Studica Multi-Mode Smart Servo features all-steel gears and large amounts of torque. This angular programmable Servo can fill a variety of roles on your robot or project. In standard mode, it operates on a +/- 150-degree range. Using the Studica Smart Robot Servo Programmer (sold separately) the Multi-mode Smart Servo can be configured to run in continuous, standard, and custom angular mode. In continuous rotation mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.  
 

• Step File

• Step File

M3 x 20mm Socket Head Cap Screw (pack of 50), Zinc Plated.

• Step File

The Studica Servo Arm Extended can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.

Specifcations:

• Spline: 25 Tooth, 3.8mm deep
• Length: 56mm
• Width: 14mm
• Height: 7.8mm
• Material: 6061-T6 Aluminum
• Step File

The Small Thrust Ball Bearing is used for vertical and axial loads to withstand heavy loads. These ball bearings have track grooves on the upper and lower track boards to reduce friction. Use these with structure for any hole where an axial load will be applied.

Specifications:

• Bore Diameter - 6mm
• Outer Diameter - 12mm
• Outer Diameter Pilot: 11.8mm
• Ball Diameter: 2mm
• Height - 4.5mm
• Material: Chrome Steel GCr15
• Step file

The Remote Controller is optimized for use on many different platforms. Connect with the included USB cable or in Bluetooth mode. Includes a built-in gyroscope, accelerometer, and 3.5mm Stereo interface for headphones and microphones. The built-in battery has a 5 to 6 hour working time, and the charging time is 2 to 3 hours. Weight is 300g.