The Studica Threaded Pattern Plate can be used to join two different structure components together.
Specifications:
Rubber Grommets are made for the Studica channel and plates and or any structure with a 14mm hole. Use it for protecting wire or as a bumper.
Specifications:
Made of Nylon, the Studica Rubber Foot is used with the Studica Robotics building structure and for many other uses.
Specifications:
The Studica U-Channel Bumper is connected to the end of the Studica 48mm U-Channel and helps remove sharp corners that can cause damage when the robot is bumping into other objects. It also creates an ecstatically clean finish to your robot.
Specifications:
The Studica Face Bearing Block can be mounted on any Studica channel and bracket providing which will allow for a 6mm ID through hole for 6mm shafts (axles). It has a permanently installed Standard Sealed Bearing. Has 8 x M3 tapped through holes for easy mounting.
The Studica Servo Spline Gear is a 30 Tooth Gear with a 25 Tooth Spline. It is used with the Studica Multi-Mode Smart Servo or Studica Multi-Mode Smart Servo 200.
Specifications:
The M3 x 10mm Low Profile Screw has a Countersunk Hex Socket Flat Head with a matching Kep Nut. This set is made for the Slide Rail, 288mm Length, 180mm Stroke and the Slide Rail, 384mm Length, 240mm Stroke
Includes,
· 450mm Length
· 3 position
· TJC8 MH-FC on one end
· TJC8 FH-MC on the other end
· Twisted cable
· Colors: White, Red, Black (red in middle)
· 24AWG Guage