The Studica Servo Arm can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.

Specifcations:

• Spline: 25 Tooth, 3.8mm deep
• Length: 33mm
• Width: 14mm
• Height: 7.8mm
• Material: 6061-T6 Aluminum
• Step File

The Studica Servo Hub Pro can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.

Specifcations:

• Spline: 25 Tooth, 3.8mm deep
• Height: 9mm
• OD: 30mm
• Material: 6061-T6 Aluminum
• Step File

The Studica Threaded Joiner Plate can be used to join two different structure components together, such as U Channel and brackets.

Specifications:

• Length: 24mm
• Width: 22mm
• Height: 3mm
• Holes: 10 x M3 x 3mm Tap Through
• Material: 6061-T6 Aluminum, Blue Anodized
• Step File

The Studica Threaded Pattern Plate can be used to join two different structure components together.

Specifications:

• OD: 28mm
• ID: 14mm
• Thickness: 3mm
• Holes: 8 x M3 x 3mm Tap Through
• Material: 6061-T6 Aluminum, Blue Anodized
• Step File

Rubber Grommets are made for the Studica channel and plates and or any structure with a 14mm hole. Use it for protecting wire or as a bumper.

Specifications:

• Outside diameter: 18mm
• Inside Diameter : 11mm
• Hole fitting diameter: 14mm
• Thickness: 9mm
• Step File

Made of Nylon, the Studica Rubber Foot is used with the Studica Robotics building structure and for many other uses.

Specifications:

• Material: Nylon
• Outside OD: 24mm
• Inner OD: 21mm
• Height: 24mm
• Step File

The Studica U-Channel Bumper is connected to the end of the Studica 48mm U-Channel and helps remove sharp corners that can cause damage when the robot is bumping into other objects. It also creates an ecstatically clean finish to your robot.

Specifications:

• Material: Silicomn/Rubber
• Hardness: 50-60 Shore A
• Length: 48mm
• Width: 48mm
• Thickness: 10.75mm
• Color: Black
• Step File

The Studica 6mm D Shaft Face Bearing Block can be mounted on any Studica channel and bracket providing which will allow for a 6mm ID through hole for 6mm shafts (axles). It has a permanently installed Standard Sealed Bearing. Has 8 x M3 tapped through holes for easy mounting.